Up to 2 year(s) limited warranty against manufacturer defects from Shure Singapore. During the warranty period, the manufacturer's appointed authorised service centre will, at its sole discretion (a) repair the product using new or refurbished parts, (b) replace the product with a new or refurbished product.
The 1/3 RU ANI4OUT Dante Mic/Line Audio Network Interface Unit from Shure is an interface unit with four Block output ports that convert a Dante digital audio signal to four line or microphone analog signals for audio routing and browser-based control. It features a single Ethernet port, customizable EQ settings, channel summing, and LEDs that indicate the device status and audio signal. It is compatible with third-party control systems.
- Single Ethernet port carries Dante audio, power (PoE - class 0)
- Control strings for third-party preset controllers including Crestron and AMX
- Four band C/S PEQ on every channel
- Provides channel summing to combine Dante signals from the network and send them over a single analog output
- Browser-based software control for all device parameters, per output channel for mute control, digital gain, and polarity control
- Chassis ground screw provides common chassis ground for multiple inputs
Key Features
- Four Block Analog Outputs
- Single Ethernet Port
- LEDs Indicate Device Status/Audio Signal
- Crestron & AMX Control Strings
- 4-Band C/S PEQ
- Browser-Based Software Control
Technical Specifications
- General
- Input: RJ45
- Output:
- ANI4OUT-XLR (4): XLR connector
- ANI4OUT-BLOCK (4): 3-pin block connector
- Configuration: Impedance Balanced
- Polarity: Non-inverting, any input to any output
- Power Requirements: Power over Ethernet (PoE), Class 0
- Power Consumption: 10W, maximum
- Weight: 663 g (1.5 lbs)
- Dimensions H x W x D: 4 x 14 x 12.8 cm (1.6 x 5.5 x 5.0 in.)
- Control Application: HTML5 Browser-based
- Operating Temperature Range: −6.7°C (20°F) to 40°C (104°F)
- Storage Temperature Range: −29°C (-20°F) to 74°C (165°F)
- Networking
- Cable Requirements: Cat 5e or higher (shielded cable recommended)
- Audio
- Frequency Response: 20 to 20,000 Hz
- Input (Dante Digital Audio)
- Channel Count: 4
- Sampling Rate: 48 kHz
- Bit Depth: 24
- Latency Does not include Dante latency: 0.71 ms
- Dynamic Range (Dante-to-Analog) 20 Hz to 20 kHz, A-weighted, typical: 117 dB
- Total Harmonic Distortion @ 1 kHz, -20 dBFS Output, 0 dB analog gain: <0.05%
- Output Clipping Level
- Line: +20 dBV
- Aux: +0 dBV
- Mic: -26 dBV
- Analog Output Level
- Selectable:
- Line: 0 dB
- Aux: - 20 dB
- Mic: -46 dB
- Selectable:
- Output Impedance: 150 Ω
- Built-in Digital Signal Processing
- Per Channel: Equalizer (4-band Parametric), Mute, Invert Polarity, Gain (140 dB range)
- System: Audio Summing
- Product Type:
- Microphone
Related Products
-
-
Shure ANI4IN 4-Channel Dante Mic/Line Audio Network Interface Unit (XLR Inputs)
Pricing available upon request
Shure
-
-
